Show 9 Of 24
Showing 9 Of 24 results
Part # M-533 | Model Year 26-31
The Ford car was designed to use this extra heavy clinging type oil in the rear axle. This oil is almost a grease in weight and clings to the ring gear. Do not overfill. New squeeze bottle with a pour spout. Model T requires 1 quart for the rear axle. Model A requires 2 quarts total for the rear end, transmission and steering box. U.S.A.
Part # M-6007 | Model Year
Stops head gasket leaks! Unlike Ceramic Motor Seal, this product can be mixed with your antifreeze and left in the vehicle. Repairs leaking head gaskets and cracks in cylinder heads and engine blocks. One pint is enough for any Model A or Model T coolant system. U.S.A.
Part # M-6006 | Model Year
Permanently seals engine coolant systems. Seals porous castings, and gaskets, works on either aluminum or iron blocks. You must drain your anti-freeze from the system and fill system with water and Ceramic Motor Seal. Run motor for recommended time per instructions on the bottle and then drain all coolant. Refill with your original or new coolant.
Part # M-8006 | Model Year
Industrial strength cleaner for your coolant system. Loosens and removes rust, scale, grease, oil and sludge. Instructions for use imprinted on bottle and listed below in Installation Instructions. U.S.A.
Part # A-12210-L | Model Year 09-31
A well lubed cam prolongs life of the points, and gives better performance. Special blend just for distributer cams. U.S.A.
Part # M-218 | Model Year 26-31
Ford green engine paint in a quart can for those touch ups once the engine is already in the car. The same color as our M-200 aerosol can. Not for sale in California. U.S.A.
Paint is enamel.
Part # M-211 | Model Year 09-25
On the early T motors prior to 1926, the block was left bare. This 'cast blast' paint gives the block a bare cast appearing finish. We offer this paint in aerosol cans. U.S.A. NOTE: Due to FAA restrictions, we cannot send paint by air. U.S.A.
Part # M-200 | Model Year 26-31
Ford green engine paint in 12 oz. spray cans. One can will do the job if your engine is already painted. On new jobs it's best to buy 2 cans. 1926-31. U.S.A.
Part # A-9002-E | Model Year 09-31
Use this when preparing your gas tank for the A-9002 sealer. Removes light rust inside the tank and leaves a gray phosphate coating. 16 oz. U.S.A.