Tools

|
Show 36 Of 60
Showing 36 Of 60 results
Part # T-2815-T | Model Year 09-27
This tool is designed to chase the threads on the hub where the hub cap threads on. It will not cut new threads, it is only designed to chase existing threads.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$99.00 EA
Part # T-3066-MK | Model Year 09-27
This kit gives you a third hand to aid in installation of the manifolds. Bracket threads onto 2 of the manifold studs so the knurled headed bolts can be turned in by hand to hold the manifolds in place while you install the original clamps and nuts on the other two manifold studs. Once you have two clamps in place you remove this tool and replace it with the original clamps. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$29.95 SET
Part # T-3079-CK | Model Year 09-27
This handy tool allows you to check the oil without getting under the car. Opens and closes petcocks on the crankcase. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$12.95 EA
Part # T-3061-W | Model Year 09-27
A large wrench for installing or removing the T-3061 exhaust pipe pack nut. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$73.95 EA
Part # T-3172 | Model Year 09-27
A simple but very useful little tool for timing your Model T. Used to determine the piston position so you can properly bend your spark rod so that the spark plugs are firing at the proper time. The T-3536 rod bending tools are very helpful for performing the rod bending task. Instructions included. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$5.00 EA
Part # A-6304 | Model Year 09-31
Plastigage takes the guess work out of putting the proper clearance in rod and main bearings. A must when checking or adjusting bearing clearance. .001-.003 U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$5.75 EA
Part # T-3052-015R | Model Year 09-27

Reamer used to bore the block when going from Standard valves to .015" oversize valves. U.S.A.

Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$67.50 EA
Part # T-3052-030R | Model Year 09-27
Reamer used to bore the block when going from .015" oversize valves to .030" oversize valves. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$67.50 EA
Part # T-3058-DR | Model Year 09-27

.452" reamer needed when going from a standard size tappet to a .015" oversize tappet. Reams the tappet guide in the block. U.S.A.

Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$92.50 EA