Part #
T-2713-FC
|
Model Year
09-27
When installing new T-2713 spindle bushings, the face of the bushing must be cut to fit your application. This tool slips inside the bore of the bushing and faces the head properly. U.S.A.
Part #
T-3050-BT
|
Model Year
09-27
Socket style tool for removing or installing the cam gear lock nut. U.S.A.
Part #
T-3339
|
Model Year
09-27
When adjusting the three clutch fingers through the inspection cover of the transmission, you need a gap of 13/16" between the "clutch shift" and the "drive plate shaft flange." Since the area that needs the 13/1" gap is difficult to get to! This handy tool will slip into that area so you can adjust your three finger clutch finger screws to the proper clearance. Instructions included. U.S.A.
Part #
T-4060-X
|
Model Year
09-25
Plier type tool used for forming split rivets to hold the cowl lacing to the firewall. Will NOT work on applications when you can't access the rivets on both sides such as 1926-27's. U.S.A.
Part #
T-3368
|
Model Year
09-27
Broken crankshafts are often caused by a misaligned tailshaft on the transmission. This tool aligns the tailshaft of the transmission with the pan and hogshead. Works on original size tailshafts as well as tailshafts turned to 1.5" for bearing style ball cap. U.S.A.
Part #
T-3100-DLX
|
Model Year
09-27
Made of heavy square steel channel. Folds flat and has steel castors for mobility. U.S.A.
Part #
T-3079-CKW
|
Model Year
09-27
A handy multi-function tool. Used for opening and closing the fuel and oil petcocks and has a pin on the end for cleaning out the petcocks. Wooden handle. U.S.A.
Part #
T-2531-BT
|
Model Year
09-27
Use this kit to remove the old T-2531-B dowel pins. Simply drill old dowels, tap the hole, thread in a screw, and pull on the screw using a pry bar. U.S.A.
Part #
T-2595-AT
|
Model Year
09-27
Used to twist the drive shaft when installing the rear end under the T. U.S.A.