Cowl Light / Tail Light

These unique bulbs are staggered pin dual filament with a low profile that will fit in lamps where a conventional bulb won't! Use these in our A-13412-DC socket. Overall height is only 1-3/8". Clear globe 21/3 candle power 12 volt, the 6 volt bulb is now a brighter 21/6 candle power.

A beautifully polished brass lamp with a red lens. When illuminated, STOP will appear in the lens. U.S.A.

A reproduction of the original Ford switch that was made in 1926-27. Mounts to the starter bendix cover and is activated with the outward movement of the pedal shaft. Now improved and U.S. Made!

The brass cap to finish off the Jno.W. Brown tail lamp. This is for the model #115. Has correct imprint on top. 1913-14 U.S.A.

Used on the 1926-27 fender mounted tail lamps that had the single bulb in them. Slides over socket and seals the T-6445-CX lens to the lamp housing. U.S.A.

For the 25-27 pick-up, this is the bracket you need to attach the tail light to the bed. Attaches to the cross member under the bed. U.S.A.

Plate goes under the fender and gives support to the fender mounted tail lamp. Works on the right or left fender. U.S.A.

This is the thin red plastic celluloid lens used on the 1926-27 tail lights only. Sits on the face of the T-6445-CX before the lens retainer (rim) slips over and holds it in place. U.S.A.

For side and tail lamps. This is missing on most lamps. Made of brass and used on Corcoran, J. Brown, and Victor. U.S.A.