Part #
T-2909
Model Year
09-25
Part #
T-2909-F
Model Year
26-27
A length of steel gas line to run from your sediment bowl to the carb. Routing instructions are included. 1/4 OD. U.S.A.
Part #
T-2916
|
Model Year
21-27
Two piece clamp with bolt & nut to hold the gas line in place. U.S.A.
Part #
T-2910
|
Model Year
09-27
Brass gas line fittings. Use felt packing for seal. Need 2 per car. U.S.A.
Part #
T-2913
|
Model Year
09-27
Felt seal for the original gas line pack nut. Need 2 per car. Also used on the spark and gas rods. These 2 small felts are slid over the spark and gas rods after you insert them through the upper bushing. They go about 14" from the handle end. U.S.A.
Part #
T-2900-D
Model Year
13-20
Part #
T-2900-E
Model Year
20-25
Made of good heavy galvanized steel with soldered joints. All tanks have inlets and outlets installed.
Gas cap must be purchased separately Only the speedster and torpedo tanks come with a gas cap. U.S.A.
Part #
T-2919
|
Model Year
26-27
Ribbed pads that go between the bottom of the gas tank and the steel straps that hold it in place. U.S.A.
Part #
T-2902-B
|
Model Year
12-27
Ford originally made this part in brass and cast iron. This unit is all brass and can be used on all years except the 26-7 s that had the tank mounted in the cowl. A-8115-OR Drain petcock must be purchased separately. Note: Requires T-2910 Gas Line Pack Nuts and T-2913 Gas Line Seals to complete installation. U.S.A.
Part #
T-2902-C
|
Model Year
26-27
Used on 1926-27 T's that had the gas tank mounted in the cowl. Unit is cast brass so it won t corrode. This is a quality American made unit! Powder coated black! Note: Requires T-2910 Gas Line Pack Nuts, T-2913 Gas Line Seals and T-6905-OR Elbow to complete installation. U.S.A.
Part #
T-2905
Model Year
09-25
Part #
T-2905-B
Model Year
26-27
A lead gasket for the gas sediment bowl flange. U.S.A.