Gas Tank

Chrome plated brass cap that fits our T-2900-M, T-2900-MB, T-2900-R, and T-2900-RB gas tanks. U.S.A.

A rubber gasket held in place with a wire which is furnished in the kit. U.S.A.

Electronic fuel pumps were never used originally but are required in some circumstances. We offer these pumps in both 6 and 12 volt versions.

When running fuel pumps on the Model T's and Model A's, you normally need to cut back the fuel pressure. This regulator does the trick, the knob on the face turns easily to adjust the fuel pressure from 1 to 5 lbs. This regulator has 1/8" female pipe threads in and out. Includes 3 pairs of brass hose barb fittings for 1/4", 5/16" and 3/8" rubber fuel line.

Replaces the elbow fitting where the fuel line enters the carb. Sure beats crawling under the car to shut off the gas! All brass construction and American made! Note: Requires T-2910 Gas Line Pack Nuts and T-2913 Gas Line Seals to complete installation.

Used only on the 1926-27 Model T's with the fuel tank in the cowl section. Kit comes with the drain pipe, clamping bolt that secures the pipe to the firewall and the screw that holds the pipe to the tank outlet. U.S.A.

The early bung style of gas cap. It is die cast just like the original, includes gasket.

Used from 1924-27, this cap has a splash guard crimped to the bottom to prevent fuel from splashing directly into vent hole in top. Die cast and includes gasket.

U.S.A.