Part #
T-3058-F
Model Year
09-27
Part #
T-3058-G
Model Year
09-27
Part #
T-3058-H
Model Year
09-27
Part #
T-3058-C
Model Year
09-27
Part #
T-3058-D
Model Year
09-27
Part #
T-3058-E
Model Year
09-27
Available in Single or double lock. Either will give you the same end result, just that the single locks are easier to adjust since you need only two wrenches instead of three.
Sold in sets of 8 only. Valve stems may need to be ground to give proper clearance due to block variations. U.S.A.
Part #
T-3110
|
Model Year
12-21
A good replacement for those damaged or missing side covers. Not exactly like the originals, but they do the job. Need 2 per car. For 2-pc. design valve covers only. U.S.A.
Part #
T-3111-C
|
Model Year
21-27
For the later style one piece style. U.S.A.
These are the original style solid tappet. If the guides are worn, ream them and use an oversize tappet. Standard size is .437. Complete sets only. U.S.A.
Part #
T-3058-LB
|
Model Year
09-27
Screws into the end of the tappet to adjust valve clearance. Double lock tappets only. U.S.A.
Part #
T-3058-DR
Model Year
09-27
Part #
T-3058-ER
Model Year
09-27
If you are replacing the standard valve tappets with an oversize, you will need one of these reamers to bore the block out to accept the larger size. U.S.A.
Part #
T-3058-T
|
Model Year
09-27
Set of 3 wrenches needed for adjusting double lock or single lock tappets. U.S.A.
Part #
T-3112
|
Model Year
12-24
Studs to secure the early 2-piece style valve cover to the block.1912-24 Price is for a pair of stud and nuts. U.S.A.