Distributor & Timer

|
Show 27 Of 37
Showing 27 Of 37 results
Part # T-3161-T | Model Year 19-27
Uses Bosch head and stainless steel shaft, rides in sealed ball bearings. Uses 1 control rod instead of 2. You'll still need a A-12000 coil, A-12000-CB coil bracket, and a T-3161-WK wire kit to complete it. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$399.00 EA
Part # T-12105 Model Year 19-27
Part # T-12199 Model Year 19-27
Part # T-12199-L Model Year 09-27
Part # T-12200 Model Year 19-27
Part # T-12300 Model Year 19-27
These parts are repair parts for the T-3161-T, T-3161-BPK and T-3161-BPF aftermarket distributors that we offer in our parts catalog.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
Part # T-2715-D | Model Year 15-27
The later lift-up style oiler was pressed into the timer. the earlier style was brass and threaded into the timer. The early brass one had a knurled brass lid that was held in place with a spring. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$2.50 EA
Part # T-3177-M | Model Year 09-27
A modern type seal that presses into timing cover in place of the original felt. NOTE: There is a lot of variation in the timing covers where this seal fits. If your timing cover was bored on the low side of the tolerance, these seals press in nicely. If your timing cover happens to have been bored on the high side of the tolerance, the seal will be too loose and will require additional sealant. We recommend JB-Weld or similar epoxy for locking the seal to the timing cover. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$4.95 EA
Part # T-3221-B | Model Year 12-27
The brush only for our New Day Timer. Steel construction with a long wearing contact. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$9.95 EA
Part # T-3221 | Model Year 12-27
We feel that this is the best timer that you could use. It is made of bakelight with copper contacts that make it trouble free. Complete with brush assembly. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$75.00 EA
Part # T-3154 | Model Year 09-27
Attaches to the front of the timing cover and the bell crank rotates on this.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$13.95 EA
Part # T-3153 | Model Year 09-27
The adjusting arm for the original Bosch plate.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$44.00 EA
Part # T-3172 | Model Year 09-27
A simple but very useful little tool for timing your Model T. Used to determine the piston position so you can properly bend your spark rod so that the spark plugs are firing at the proper time. The T-3536 rod bending tools are very helpful for performing the rod bending task. Instructions included. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$5.00 EA