Part #
T-4727-B
|
Model Year
15-17
One piece stamped style with rounded corners. Taller on the front so coils could be removed easier. Used from 1915 through early 1917.
Part #
T-5004
|
Model Year
15-25
This is the later 3 piece style coil box lid that was correct for 1917-25 but it will also fit 1915-16 boxes that had the 1 piece style lid. Made out of 20 gauge steel like original. Latch (T-4600-BLS/T-4600-NLS) not included and must be ordered separately if needed.
Part #
T-5004-B
|
Model Year
26-27
Replacement for the 1926-27 coil box that was mounted on the motor. Comes with latch clips.
Part #
T-5004-C
|
Model Year
26-27
Sponge type gasket material that was inserted in coil box lid for a tight seal. U.S.A.
Part #
T-4602-SC
|
Model Year
09-13
#10 x 3/8" high, round headed, slotted brass screws just like originals.
Part #
T-4725-XE
Model Year
15-21
Part #
T-4725-XB
Model Year
22-23
Part #
T-4725-XF
Model Year
23-25
Correct carriage headed bolt with 1/2" diameter hex nuts to hold the coil box to the firewall. U.S.A.
Part #
T-5001-RK
Model Year
13-25
Part #
T-5001-RKB
Model Year
Modern plastic material that replaces the wood inside the coil box. Not affected by moisture or water! Eliminates shorts and misfires! Includes mounting hardware. U.S.A.
Part #
T-5005-TN
|
Model Year
09-13
Set of 15 brass knurl nuts. 10 are used for attaching wires to the terminal box, 4 are used for attaching wires to the early style timer, and 1 for the mag wire on the magneto post. U.S.A.