Part #
T-6201-G
|
Model Year
18-20
The last float you will ever buy! Made of modern material resistant to alcohol. Hardware included, use old hinge. 2-7/8" O.D., 2" I.D., 1-1/2" High. U.S.A.
Part #
T-6279
|
Model Year
26-27
The lower portion of the air adjusting needle. This is used only on the vaporizer carb. You will need to purchase the T-4132 to complete the unit. U.S.A.
Part #
T-6283
|
Model Year
26-27
The brass seat used in the vaporizer carb. U.S.A.
Part #
T-6215
|
Model Year
20-20
Only used on the early Holley NH carburetor in 1920. Prior to the bowl vent being under the carb data tag, Holley used this drilled plug as a vent.
Part #
T-6173-A
Model Year
15-22
Part #
T-6173-B
Model Year
20-23
Part #
T-6173-C
Model Year
24-26
Threads into the side of the carb and the air valve pivots
Part #
T-6171
|
Model Year
21-26
Air stop assembly used on the Kingston L4 carburetor from 1921-26. Screws into the top of the carburetor and has a piece of cork in it for the air valve to bump against.
Part #
T-6171-C
|
Model Year
21-27
Used on the Kingston L4 carburetor. This small round cork goes inside the air valve stop. When the air valve bounces up in the carb, it bumps against this cork. U.S.A.
Part #
M-205
|
Model Year
09-31
16oz Aerosol semi-gloss black enamel. Gas resistant, works great on carburetors or anywhere else throughout where a semi gloss black paint is required. 300 degree temp rating. U.S.A.
Part #
T-6203
Model Year
16-27
Part #
T-6044
Model Year
13-21
Part #
T-6050-L
Model Year
15-16
Goes between carb casting and fuel bowl. U.S.A.