Brakes Hand

|
Show 9 Of 17
Showing 9 Of 17 results
Part # T-3448-H Model Year 09-25
Part # T-3448-BH Model Year 26-27
Laser cut and heat treated for long life. You get full tooth contact with these quadrants! Made in Sweden.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA
Part # RT-2003 | Model Year 09-27
Attaches hand brake quadrant to the frame. Four 1/4 D x 7/8" round head. See Model A section under "RIVETS" for installation tools.
DISCONTINUED
Temporarily
OUT OF STOCK
$2.50 SET
Part # T-3467-OR | Model Year 09-27
The two prong style clevis for the brake rods. Replacement style is forged. (A-2461) Original style is rolled steel. (T-3467-OR). U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$6.95 EA
Part # T-3472 | Model Year 09-27
Special carriage bolt that holds the brake rod support to the frame. Nuts included. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$0.50 EA
Part # T-3470-R Model Year 09-25
Part # T-3470-L Model Year 09-25
These brackets bolt to the radius rod and support the brake rod in the middle. Will work on all years but are actually correct for 1914-27. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA
Part # T-3468-A Model Year 09-17
Part # T-3468-B Model Year 18-25
Part # T-3468-C Model Year 26-27
Part # T-3468-TT Model Year 09-27
U.S. made brake rods with correct ends. The early rods have cast clevises and the later rods use a stamped clevis. Good Quality! U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA
Part # A-2461 | Model Year 09-34
This 2-pronged clevis is used on the brake pedal to cross shaft rod. Forged. 5/16"-24 thread. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$4.95 EA
Part # T-3456-B | Model Year 09-27
Holds the hand brake lever onto the cross shaft. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$0.45 EA
Part # T-3458 | Model Year 09-27
The pawl for the hand brake. Very good quality U.S. made. Don't forget to order a new T-3459 pin for installation. Left hand drive only. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$6.50 EA