Part #
RT-2005
|
Model Year
09-27
Round headed steel rivet used to attach the axle housing tubes to the ends and center section. 7/32" x 3/4". U.S.A.
Part #
T-2510-A
|
Model Year
09-27
A large steel washer that fits between the outer felt oil seal and the bearing. Need two per car. U.S.A.
Part #
T-2506-B
|
Model Year
09-27
Originally this was a hard fiber washer. This washer is .020" thicker than the fiber washer and will wear much better. This washer is .080" thick. Goes between the 2 axle shafts in the center of the rear end. U.S.A.
Part #
T-2500-CAST
|
Model Year
09-27
14 cadmium plated rear axle and drive shaft nuts. U.S.A.
Part #
T-2515
|
Model Year
09-27
Set of 3 castle nuts for the left and right differential cases. U.S.A.
Part #
T-2514
|
Model Year
09-14
The studs that hold the differential case together inside the rear axle. 3 are required. U.S.A.
Part #
A-4030
|
Model Year
28-48
The original style. Can be used to fill and drain. Some of the 1926-27 T's used this style of oil plug which is 1/2" pipe thread. U.S.A.
Part #
T-2521-B
|
Model Year
11-27
Used in attaching the gear on the axle shaft. U.S.A.
Part #
T-2519-A
|
Model Year
09-27
These lock the differential gear onto the axle shaft. Need 2 per axle. U.S.A.