Part #
T-2715-D
|
Model Year
15-27
The later lift-up style oiler was pressed into the timer. the earlier style was brass and threaded into the timer. The early brass one had a knurled brass lid that was held in place with a spring. U.S.A.
Part #
T-2705
Model Year
Part #
T-2706
Model Year
These are the outer ball retainers for the old ball style wheel bearings. U.S.A.
Part #
T-2714
|
Model Year
09-27
Rolled steel bushings for the spindle arm. 2 are required. U.S.A.
Part #
T-2697
|
Model Year
11-27
Holds the spindle arm onto the spindle body. U.S.A.
Part #
T-2713
Model Year
09-27
Part #
T-2713-Q4
Model Year
Just in case you reamed 'em too big, we sell the bushing only. Well machined brass. When installing they must be reamed and faced for proper fit. U.S.A.
Part #
T-2713-T
|
Model Year
09-27
This tool is used for driving the T-2713 bushings into the spindle. U.S.A.
Part #
T-2713-R
|
Model Year
09-27
After T-2713 bushings have been installed they must be reamed for the spindle bolt to fit. This special reamer reams both upper and lower bushings at the same time so they are aligned with each other. This is not an of-the-shelf reamer, it is made just for the Model T.
REAMER DIAMETER - .504"
Part #
T-2713-D
|
Model Year
09-27
Use this tool to easilly remove the T-2713 spindle bolt bushings from the spindles. U.S.A.
Part #
T-2707
Model Year
09-27
Part #
T-2708
Model Year
09-27
These thread onto the front spindles after the spindle washers. One is left handed thread and the other is right handed. U.S.A.