Front

|
Show 9 Of 30
30 Results
Part # T-2728-ACC | Model Year 09-27
Apco accessory style spring loaded ball cap kit. For use on the tie rod and drag link. Takes two per car, replaces T-2728. Comes with ball seat, spring, cotter pin and end plug. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$33.75 EA
Part # T-2691 | Model Year 09-27
An 8 piece castellated nut set for the front axle & steering. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$7.95 SET
Part # T-2728-C | Model Year 09-27
This is the seat for the accessory style spring loaded radius and tie rod cap assemblies. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.75 EA
Part # T-2714-T | Model Year 09-27
This driver is used for installing and removing the T-2714 bushing. Prevents damage to spindle arm. Also used to install the A-2227 bushings in the brake camshaft housing and in the brake toggle lever housing. It is NOT used to drive out old bushings. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$16.95 EA
Part # T-2713-FC | Model Year 09-27
When installing new T-2713 spindle bushings, the face of the bushing must be cut to fit your application. This tool slips inside the bore of the bushing and faces the head properly. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$62.95 EA
Part # T-2725-A Model Year 09-11
Part # T-2725-B Model Year 11-13
Part # T-2725-C Model Year 13-16
Part # WEB-KIT-0066 | Model Year 09-27

These drag links are authentic in every detail! There are cheaper drag links on the market today but the quality and workmanship just can't compare! Ends are investment castings with a very smooth finish.

Early links have the authentic style nuts included, not your standard "off-the-shelf" nuts. The 1913-16 drag link has the ends brazed in place and pinned as original. U.S.A.

DISCONTINUED
Temporarily
OUT OF STOCK
Part # T-2729-BMB | Model Year 09-27
The correct design bolts to hold part #T-2728 onto the drag link. With castle nuts and cotter pins. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$3.95 SET
Part # T-2709-E | Model Year 09-19
These spindle washers are used between the outer bearing and the spindle nut. This washer is thinner than our T-2709 washer and are to be used on early style spindles that are being used with the tapered style Timken bearings instead of the old individual ball bearings. SOLD EACH, not in pairs.
DISCONTINUED
Temporarily
OUT OF STOCK
$14.50 EA
Part # T-2710-AS Model Year 09-15
Part # T-2710-ASB Model Year 09-16
Part # T-2710-BS Model Year 09-27
Part # T-2710-BSB Model Year 17-27
Part # WEB-KIT-0061 | Model Year 09-27

These are the original style with precision machine ground bolts. The set comes with enough bolts, bushings, nuts, cotter pins and oilers for both sides. The 1909-16 set comes with the original style brass twist style oilers.

The 1917-27 set comes with flip top oilers. One set does a car. U.S.A.

DISCONTINUED
Temporarily
OUT OF STOCK