Windshield Wiper

|
Show 18 Of 61
Showing 18 Of 61 results
Part # A-14593-A | Model Year 28-30
These clips installed inside the car firewall to hold the wire that ran to the cowl lights and for the windshield wiper. 1928-29 U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$4.00 EA
Part # A-14593 | Model Year 28-31
Used on open cars to hold the wire going to the wiper motor. Also so used to support the cowl light wire 3 per car. 1930-31 U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$4.00 EA
Part # A-17565 Model Year 28-30
Part # A-17565-AR Model Year 27-28
Part # A-17565-MB Model Year 27-28
Cad plated flat steel arm made exactly like the original. This is a show quality repo for the original electric wiper motor. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
Part # A-17528-A Model Year 28-29
Part # A-17528-A1 Model Year 28-29
Part # A-17528-A2 Model Year 29-30
Part # A-17528-C Model Year 28-30

Authentic style wiper blades for Model A's with electric wiper motors. All are designed to use cotter pin hole for attaching. U.S.A.

Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
Part # A-17675 | Model Year 28-31
Used on all of the original electric wipers for connecting the wire to the motor. One end of this fiber connector has a spring loaded female hole in it that snaps over the bullet shaped electrical connector of the wiper motor. The other end has a place to slide a stripped wire in and a brass set screw holds the wire in place.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$9.95 EA
Part # A-17507-6 Model Year 28-31
Part # A-17507-12 Model Year 28-31

Finally! An electric wiper kit that is a direct replacement for the old electric or vacuum wiper motor that mounted to the outside of the closed car windshield frame.

The windshield can still be opened (about 2-1/2 to 3 inches) for fresh air. Motor will accommodate mounting hole spacing 4-1/4" to 5-1/8." Motor protrudes out from windshield 4-1/8." Motor has automatic stop position.

Kit comes with motor, wiper arm, blade wiring, switch and instructions for mounting. Switch is concealed behind dash rail.

Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
Part # A-17655-AR | Model Year 28-31
Chrome plated hand wiper used on all open cars until Oct. of 1928. Commercial A's until June 1930.  Same type as used by Ford.  Fits through a hole drilled in the windshield frame.  Shaft must be lengthened to work on closed cars.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$34.50 EA
Part # A-6621 | Model Year 28-31

This slotted pipe plug goes on the side of the block near the bottom where the oil pump slips up in. You open this to see if your pump is pumping. Quite often you will find a bolt where this plug is supposed to be. U.S.A.

Use this 1/8" pipe thread plug to plug off a vaccum wiper hole in the intake manifold if it is no longer needed.

Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$0.75 EA
Part # A-17522 | Model Year 28-31
Goes from the firewall under the gas tank, and up the stanchion post on the closed cars. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$9.95 EA