Part #
A-79501
|
Model Year
28-31
This windshield frame gasket is special for the reproduction aluminum windshield frames. Does both sides and the bottom. It is a "T" shaped profile of rubber instead of the rubber all of the other body styles used. U.S.A.
86 1/2" long
Part #
BWO-3031-LS
Model Year
30-31
Part #
BWO-3031-LV
Model Year
30-31
On the 1930-31's this panel fits above the gas tank at the back edge. The lower part of the windshield goes against this.
Part #
BWO-3031-USW
|
Model Year
30-31
Goes from the top of the windshield to the top. Used only on the 1930-31 Station Wagon. Laminated Fiberglass. USA
Part #
A-45475-S
|
Model Year
28-31
This set is used to hold the swing arms to the windshield frame. 1 kit does both sides. If your windshield brackets do not have the threaded insert, the female nut in this kit will replace it. U.S.A.
Part #
A-79500-SW
|
Model Year
31-31
The hinge and the frame gasket used on the slant windshield cars was slightly different than what was used on earlier Model A's. This kit will give you both the hinge and frame rubber. U.S.A.
If you only need the frame gasket and NOT the hinge gasket, you can order our A-79500 frame rubber as it is the same.
Part #
A-45460-AR
|
Model Year
28-29
Only used on the 60-A and 60-B Briggs Leatherback Fordor Sedans. Bolts to the windshield frame. Sold individually, two required. U.S.A.
Part #
A-45482
|
Model Year
28-32
Chrome plated nuts to hold the swing arms when you open the windshield on closed cars.
Part #
A-45477
|
Model Year
28-31
These chrome cup shaped washers have a hard rubber insert that sets in them for going against the swing arms to grip better. 1 set does both sides. U.S.A.
Part #
A-45463-60AB
|
Model Year
28-29
Unpolished stainless steel swing arms that were originally used on the 1928-29 Briggs Leatherback 4-doors.