For the water pump. 2 required. U.S.A.
Also sets in the T-3982 fan cup. U.S.A.
The impeller only for the pump. This is a press fit, no need for a pin. With impeller installed it should be 8-3/8" from base of impeller to end of shaft.
The cut version is ground to slow down the flow rate. Use the cut version with reproduction radiators to eliminate coolant pumping out the overflow pipe. 1928-31, U.S.A.
Pump has a sealed ball bearing in the front and uses a stainless steel shaft with a snap ring in front of the bearing to prevent end play.
Back end of the pump uses the A-8512-BR/ZR cartridge that we sell. The positive aspect of this pump is that you never have to grease it. The drawback is, if the seals ever fail in the cartridge, you don't have an original nut with packing for a back-up like you do with our A-8502 style leakless pump.
The impeller is the cut down version. Grease fittings are for appearance only, gasket and fan mounting kit are included. One year warranty. 4-bolt design. NOTE: The brass nut is correct for 1928-29 and the zinc nut is original for 1930-31 but either will fit all years 1928-31. U.S.A.
Water pump rebuilt kit includes:
A-8554 flat bearing washers, A-8542 bearing felt, A-8540-A cup washers, A-8535 front bearing sleeve, A-8530 front bearing, A-8513-A thrust washer, A-8512-BR or -ZR sealed rear cartridge, A-8510-SSL long style stainless shaft, A-8501-IM cut impeller, A-8507 pump mounting gasket, and A-8510-MS fan mounting set.
Measure the I.D. of your pump where the rear bushing goes in, it must measure 1.015/1.016" in order to use this kit.
With this kit, you'll have to grease the front bearing but the rear cartridge does not require greasing.
The heaviest duty pump available
One year warranty
The snout of the water pump has been bored out to accept a sealed ball bearing in place of the old original roller bearing that is pressed onto the shaft to eliminate end play. It also has a sealed rear bushing assembly with a stock pack nut. The pack nut contains graphite packing as a back up.
Our no-leak Model A water pump comes with a gasket and fan mounting kit.The impeller is the cut down version. Rear bushing requires grease. 4-bolt design. NOTE: The brass nut is correct for 1928-29 and the stainless steel nut that resembles the original zinc nut is original for 1930-31 but either will fit all years 1928-31. U.S.A.