Transmission 3 Speed

This little clip holds the long spring in place on the gear shift lever. U.S.A.

This handy tool is a must for removng or installing a gear shift lever. Safely compresses the A-7227 spring in gear shifting tower. U.S.A.

Holds the shifting forks onto the shaft for the gear shift. U.S.A.

Each kit contains 2 hardened plungers and 1 spring. These mount in the transmission tower and slip into the notches in the shifter shafts. If the plungers in your transmission are worn, your car will have a tendency to slip out of gear! U.S.A.

Two of the short bearings are used. One at the front of cluster gear and the other at back of the main drive shaft.

This spacer slides over the end of the A-7060 before it is slid into the roller bearing. (A-7118) Prevents roller bearing from damage. U.S.A.

A bronze thrust washer for the cluster gear, 2 required. U.S.A.

This kit will allow you to install a transmission from a 1932-39 V-8 in your Model A. Kit includes bellhousing adapter, wishbone, handbrake, pedal and throwout bearing shaft adapters. Must use 1929-31 hand brake 1928-31. U.S.A.

RIGHT HAND DRIVE ONLY! this kit will allow you to install a transmission from a 1932-39 V-8 in your Model A The kit includes a bell housing adapter, wish bone, hand brake, pedal and throwout bearing shaft adapters. Must use with brake to the left sidestyle emergency lever.