Part #
A-47301-TA-5
|
Model Year
09-31
Nails used to secure the top moldings to the body. These were originally 3/4" long but we made them 1" long in case you have some questionable wood where the original nails were. Flat head (.150" dia) with a slight countersink under the head. Stainless steel with a ring shank. .072" diameter. U.S.A.
This is a 5 lb. box which yields approximately 4900 nails.
Part #
A-47301-A
|
Model Year
28-31
An Aluminum gutter. Two piece snap on type which you bend to the roof contour. Fasten the flat piece to the roof, and the the gutter piece will snap onto it. Will work on any car that has wood to nail into where they mount. One set does both sides. When bending, you must snap the two pieces together and bend as an assembly. Use wax paper between the two pieces when bending to make them come apart easier. These gutters are 45" long and are used for pickup trucks and coupes. U.S.A.
Part #
A-47301
|
Model Year
28-31
An aluminum gutter. Two piece snap on type which you bend to the roof contour. Fasten the flat piece to the roof, and then the gutter piece will snap onto it. 90" long. Will work on any car that has wood to nail into where they mount. 1 set does both sides. NOTE: gutters are supplied in a straight length, snap the two pieces together with a piece of wax paper between them so once you have bent them, they will come apart easily. U.S.A.
Part #
A-47301-7
|
Model Year
30-31
Fits 150-B 30-1 Station Wagon and 255-A Special Delivery. Used across front only, nails down every 2" nail heads exposed. 5 foot length.
Part #
A-37804-L
|
Model Year
29-30
This hinge attaches to the belt rail and provides an anchor and pivot point for the rear and middle bows. Fits the 68A and 68B Cabriolets, cast bronze. U.S.A.
LEFT SIDE
Part #
A-37804-R
|
Model Year
29-30
This hinge attaches to the belt rail and provides an anchor and pivot point for the rear and middle bows. Fits the 68A and 68B Cabriolets, cast bronze. U.S.A.
RIGHT SIDE
Part #
A-47778-A
|
Model Year
28-29
Used on the 1928-29 Coupe. Attaches to the side rail above the door opening just above the door post wood. Curves upward and attaches to the rib rail ledge and the wide center roof rib. Sold individually.
Part #
A-47775-L
Model Year
28-29
Part #
A-47775-R
Model Year
28-29
Part #
A-47776-L
Model Year
30-31
Part #
A-47776-R
Model Year
30-31
Part #
A-47776-PL
Model Year
30-31
Part #
A-47776-PR
Model Year
30-31
The panel above the door that rolls from the top of the door up to rib rail. You will have to put the holes in to mount the panel and the rain gutters.
Part #
A-37318
|
Model Year
29-31
Screws to the bottom of the folding door pillar and holds the dress plate seal in place. Unpolished stainless steel. Holes are drilled but not countersunk so they can be used on either the left or right side. 1929-31 Cabriolet. U.S.A.