Part #
A-3617
Model Year
28-29
Part #
A-3618
Model Year
30-31
The button, escutcheon, spring and spring base only to repair an original light switch rod assembly. Chrome button for 28-9's and a black phenolic button for the 30-1's. If you are ordering a new light rod, this will already be installed. U.S.A.
Part #
A-3616-RK
|
Model Year
28-31
The wire, contacts and insulators you will need to repair the guts of the light swich rod. U.S.A.
Part #
A-3647
|
Model Year
28-34
This holds the light switch on the bottom of the steering column.
Part #
A-3616-B
Model Year
28-29
Part #
A-3616-C
Model Year
29-29
Part #
A-3616-F
Model Year
30-30
Part #
A-3616-G
Model Year
30-30
Part #
A-3616-H
Model Year
30-31
Complete with the wire contacts, insulators, horn button and escutcheon. The length is measured on the tube part from the top of the tube where the tube goes into the head, down to the keeper groove.
NOTE: A-3616-B is used on the 7-Tooth Columns and A-3616-C is used on the 2-Tooth columns. U.S.A.
Below are shaft measurements , not light switch rod measurement. If your original light rod is missing, measure the steering shaft with a piece of string or wire.
A-3616-B = 44-1/2"
A-3616-C = 43"
A-3616-F = 44-1/2"
A-3616-G = 43"
A-3616-H = 44"
Part #
A-3643
|
Model Year
28-39
This is the part that fits the square part of the light rod and operates the light switch. Pressed steel as original. When installing, tabs of the spider should be at 12:00 and 6:00.
Part #
A-3643-T
|
Model Year
28-31
Slips around the ears of the light switch spider and gives you a large surface to push on so you can compress the spring to install the retainer. U.S.A.
Part #
A-3644
|
Model Year
28-36
The small U shaped retainer that holds the spider on the rod. Better order an extra one since they are small and easily lost. U.S.A.
Part #
A-3642
|
Model Year
28-39
This is the spring that holds tension against the spider to hold the light switch rod in place. U.S.A.