2 Tooth

If you purchase our A-3548-NOR, this is the seal we use in the end of the sector housing. Your old sector housing will need to be machined to accept this seal. Seals the sector shaft in the end of the sector housing where it bolts to the frame. U.S.A.

These bushings go in the housing where the sector goes through. U.S.A.

3 of these odd washers are required. Go under nuts that hold sector housing to steering box. 2-tooth steering boxes. U.S.A.

A new sector housing for the two tooth steering box so no core is required! Housing is fitted with needle bearings and a lip type seal to keep the oil in the box where it belongs! Fits left hand drive vehicles only.

Seals the steering sector shaft where the steering box attaches to the frame.  Simply slide the O-ring over the end of the sector shaft, then the flat steel washer, then slide the steering box/sector housing up against the frame and draw bolts tight.  Kit mounts between steering box and the inside of the frame rail.  Works on 1928-31 model A's.  USA

The screw in the steering box that controls the end thrust of the sector. This one is for the 2-tooth sector steering box. U.S.A.

This special dished washer goes between the sector and the steering box. 2-tooth only. U.S.A.

Spark and gas rods for 1930-31.  Nickel is what was used originally but we also offer them in chrome. Handle end only is plated as original.   

Set of 3 studs for mounting the 2-tooth sector housing to the steering box. The fourth stud is the special one that has the machined shoulder on it (A-3585). U.S.A.