Part #
A-3585
|
Model Year
29-31
One of these is used on the 2-tooth box. This is the special stud that has a shoulder on it. U.S.A.
Part #
T-2913
|
Model Year
09-27
Felt seal for the original gas line pack nut. Need 2 per car. Also used on the spark and gas rods. These 2 small felts are slid over the spark and gas rods after you insert them through the upper bushing. They go about 14" from the handle end. U.S.A.
Part #
A-3578-R
Model Year
28-29
Part #
A-3578
Model Year
29-31
This thin nut locks the sector thrust screw (A-3577/A-3577-R) in place on the side of the steering column. U.S.A.
Part #
A-3569
|
Model Year
29-37
This bracket bolts to the bottom of the 2-tooth steering column and the light switch body slips into it.When used with some reproduction light switch bodies, It may be necessary to enlarge the notch in this bracket. To fully engage the base of the light switch body
When bolting to the bottom of the steering column, the female notch for the light switch to engage with goes at the bottom.
Part #
A-3569-MB
|
Model Year
28-31
For the 1929-31 2-tooth steering columns, attaches the light switch bracket to the bottom of the steering column. Kit includes 2 bolts with lock washers. U.S.A.
Part #
A-3529
|
Model Year
28-31
If when you turn your steering wheel, the light switch rod turns, this might be what you are missing. This sets in the tube that the light switch rod goes into and acts as a bushing, and spaces the rod away from the steering wheel. U.S.A.
Part #
A-3552
|
Model Year
29-31
The lower steering worm bearing cup. 2-Tooth box.
Part #
A-3574
|
Model Year
29-31
This set replaces the bushings in the sector housing. It will make the car steer much easier. The old sector housing must be machined out to a larger I.D. to accept these. It is a job for a machine shop. U.S.A.
Part #
A-3527
|
Model Year
29-31
Used only on the 2-tooth steering boxes, this dish shaped steel washer retained the leather or neopreme seal where the light rod passed out the bottom of the steering box. Not used with A-3568-T.