Part #
A-17270-A
|
Model Year
30-31
This is the gear for the standard ratio rear end. This is the small gear that goes in the housing that bolts to the bottom of the torque tube. U.S.A.
Part #
A-17273-R
Model Year
28-30
Part #
A-17273-S
Model Year
30-31
This is the shaft only that goes in the gear/case assembly that bolts to the torque tube. The end of the speedo cable slides into this shaft.
A-17273-R Accepts the rounded end cable used with an oval speedo.
A-17273-S Accepts the square ended cables.
U.S.A.
Part #
A-17270-H
|
Model Year
28-31
Complete drive that includes the shaft and the gear. Only available for standard ratio rear ends. Housing only also available. This is the assembly that bolts to the bottom of your torque tube and the speedometer cable threads onto this. U.S.A.
Part #
A-17268-A
Model Year
28-30
Part #
A-17268-C
Model Year
30-31
Part #
A-17268-D
Model Year
30-31
Part #
A-17268-N
Model Year
30-31
The black plate that fits behind the plated bezel on oval or round speedos. U.S.A.
Part #
A-17300
|
Model Year
28-30
Only used on the oval Stewart Warner speedometers. Thin egg shaped disc that covers the gear mechanism beside where the speedo cable threads in. U.S.A.
Part #
A-17256-AR
Model Year
28-30
Part #
A-17256-B
Model Year
30-31
Clear glass lens for the round and the oval speedometer. U.S.A.
Part #
A-17257-AR
Model Year
28-31
Part #
A-17257-B
Model Year
30-31
Thin gaskets used to install the speedometer lens in the bezel. Gaskets come in pairs, 1 used on each side of the glass lens. U.S.A.
Part #
A-17318
Model Year
30-31
Part #
A-17318-O
Model Year
28-30
Part #
A-17318-S
Model Year
30-31
The mainspring for inside your speedo. U.S.A.
Part #
A-17255-MB
|
Model Year
28-31
The two screws, nuts, and lock washers needed to mount the speedometer in the instrument panel. U.S.A.