Seat Parts

This strip of wood is riveted onto the backrest framework of the Tudor Sedan front bucket seat assembly. Tacks to hold the upholstery in place are driven into this wood strip. Comes with mounting rivets. U.S.A.

The track assembly for the seat carriage assy. on the 1930-31 Coupes. U.S.A.

Fits the driver side seat of the 1930-31 Victoria, 1931 Deluxe Tudor Sedan & A400. U.S.A.

This steel grommet goes under the bucket seats on the hard board panel. Dlx Phaeton, A400. U.S.A.

Set of 4 metal brackets that attach the top of the rear backrest to the body. Used only on 1931 slant windshield 4-doors. U.S.A.

These clips fasten the bottom of the rear backrest in place. They attach to the body using the same bolts that bolt the rear center body section in place towards the bottom. Used on sland windshield 4-door sedans. U.S.A.

Special knurled bolts used to attach the seat legs, they are installed in your wooden station wagon seat frames before the upholstery is installed. Sold individually. U.S.A.

Clips attach to the upper horizontal piece of wood that the rear backrest spring/upholstery is mounted to. There are slots in the horizontal body brace below the back window that these clips slide into. 2 required. U.S.A.

Screws to lower horizontal seat backrest wood with two wood screws. Lower hole in clip attaches to the A-47910 bracket in the Tudor Sedan body. Screw holes are 35" O.C,. bottom of the clip should be 1" below the board it is mounted to. Two are required.