Seat Parts

Special round nut that is caged in the metal bracket on the seat assembly. Used only on the threaded style seat adj. unit. If you are ordering the A-47838 seat adjuster bracket, this nut is already installed in it. U.S.A.

This spring is about 6" long and is used on the seat adjuster of cars with the saw tooth style adjuster. U.S.A.

Used on the screw style seat adjuster. Slides down on head of seat adjuster bolt before going through bracket at the front of the seat. The original was brass, but this is a nylon for smoother operation. U.S.A.

This clip screws to the backrest wood and is what the seat back hangs on. Used on 1928-29 Coupes. 2 are needed per car. U.S.A.

Front seat backrest frames. These frames fit 1930-31 Victoria passenger side seat. Deluxe Phaeton used this frame on both driver and passenger side. 1930-31 U.S.A.

Threaded plate that attaches to the underside of the wooden sills/cross member. Threaded plate provides the anchor for attaching A-70143 seat mounting bracket. Used on early Victoria and Dlx Phaeton. Sold individually. 1930-31. U.S.A.

This is a set of the special clips that attach to the seat back wood of the 1928-29 Roadster that hold the seat spring on. U.S.A.

The pivot brackets and the seat cups for the Tudor Sedan seat assembly. One kit does one bucket seat. U.S.A.

This bolts to the seat wood and is about 12" long with a hole in it for the seat hinge rod A-70145 to pass through. For Victoria, Dlx. Phaeton. U.S.A.