Motor Meter

|
Show 9 Of 14
Showing 9 Of 14 results
Part # A-18361-N | Model Year 28-31
Thin brass jam nut that holds the moto meter on the cap. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA
Part # A-18354-J Model Year 09-31
Part # A-18354-F Model Year 28-31
Part # WEB-KIT-1034 | Model Year 09-31
A pair of back and front Boyce or Ford plates for the Junior size moto meter which is the one that we sell. If you are using one of our moto meters in another make of vehicle, you can remove the Ford plates and replace them with the Boyce face plates. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
Part # A-18385-AR Model Year 28-29
Part # A-18385-B Model Year 30-31
Part # WEB-KIT-1031 | Model Year 28-31
A beautiful reproduction of the famous original Ford accessory. Complete with the locking cap. See instructions below for 1930-31 with reproduction radiators.
DISCONTINUED
Temporarily
OUT OF STOCK
Part # A-18360-GO | Model Year 28-31
An O-ring that replaces the A-18360-G gasket in the locking style radiator cap. Often as the cap/hinge gets worn, the standard gasket does not allow the cap to close tightly. This O-ring is slightly thicker than the original gasket to give you a good seal. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$0.50 EA
Part # A-18360-BRK | Model Year 30-31
This repair kit works on any 1930-31 locking cap or quail. Includes gasket for between cap and radiator and gasket for between upper and lower parts of the locking cap, stainless screws and brass tabs.
DISCONTINUED
Temporarily
OUT OF STOCK
$7.35 SET
Part # A-18360-AR Model Year 28-29
Part # A-18360-B Model Year 30-31
Part # WEB-KIT-1029 | Model Year 28-31

This is the cap only.

The 1928-29 is threaded, and the 1930-31 has tabs.

Both lock in place with allen screws so they can't be removed without tools. See instructions below for 1930-31 with reproduction radiators. The top part of cap that flips open is drilled to accept the A-18354-CR or -WR moto meters. U.S.A.

DISCONTINUED
Temporarily
OUT OF STOCK
Part # A-18360-G | Model Year 28-31
This is the special gasket that goes between the locking cap base and the flip up lid. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA
Part # A-18361-MM | Model Year 09-31
This gasket goes between the base of the moto meter, and the locking cap. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.05 EA
Part # A-18354-RK Model Year 28-31
Part # A-18353 Model Year 09-31
Part # WEB-KIT-1033 | Model Year 28-31
Lens, gasket, and plain screws for rebuilding the Model A moto meter. The lens size is 1-11/16." If you have the wreath type of moto-meter you want to buy the embosed screws A-18356-S. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK