Part #
A-17700-PS
|
Model Year
28-31
This style of mirror clamps on the front of the door edge just above the hinge. Simply clamps on with two set screws so installation is simple. 4" mirror head. Fits any closed car. Bracket is chrome and mirror head is polished stainless. Drivers side only. You'll need about 1/8" of clearnace behind the lip of the door where you're going to mount this.
Part #
A-17681-A-CB
|
Model Year
28-29
An exact reproduction of the original that was used in the closed cars. The only American made mirror on the market today. Bracket comes powder coated black! Mirror glass is the correct size and proper bevel on the edges. Held in place with 3 screws above the windshield. Comes with beveled mirror glass. Used on 1926-27 Model T's and 1928-31 Model A's. U.S.A.
Part #
A-17741-BL
Model Year
30-31
Part #
A-17741-BR
Model Year
30-31
Similar to our A-17741-A hinge mirror except this one has an offset arm. 1.700" is the width where it slips over the top and bottom of the hinge. Chrome arm with a 4" polished stainless mirror head. Longer hinge pin included. Pin is .235" diameter.
Part #
A-17704-AMB
|
Model Year
30-31
Pan head screws and lock washers used to secure the outside (hinge style) rear view mirror arm to the door hinge. 1930-31 Closed Cab Pickup.
Part #
A-17741-HP1
|
Model Year
28-31
When installing hinge mirrors on a Model A, a longer pin is needed. If ordering new mirrors, this pin is included. Chrome finish. Not for S/W 4-doors.
Part #
A-17681-BCB
Model Year
30-31
Part #
A-17681-BCC
Model Year
30-31
This style was used on all 1930-31 closed cars. Powder coated black or chrome. U.S. made with the correct bevel on the glass.
Part #
A-17704
Model Year
28-31
Part #
A-17704-B
Model Year
28-31
Replace the old cloudy mirror with a new heavy plate mirror. Very nice mirror with beveled edges. The smaller mirror is the original size (2-1/2" x 4-1/2"), but some prefer the larger size (2-1/2" x 6"). These are American made with the correct bevel! U.S.A.
Part #
A-17728
|
Model Year
29-31
Authentic style mirror head that was used on the 1929-31 closed body style commercial vehicles. Comes with everything you see and must be assembled. Best to prime all parts first, assemble, and then paint once assembled. The outer ring is a very snug fit to the body when it gets assembled. Only works on mirror arms that secure the mirror head with a bolt in the end of the arm.
Part #
A-17727
|
Model Year
28-29
These authentic mirror heads were used on the early 28-1929 closed commercial vehicles. This style has the two brackets riveted to the back of the mirror head for the pivot ball. The pivot ball (not included) was peened into the mirror arm. Supplied in bare steel and unassembled. Best to prime everything first, assemble, and paint the assembled mirror head. They are a very snug fit where the rim and housing press together.