Part #
A-11655/67
|
Model Year
28-31
Mounts on bottom of steering column. The light wire harness slips inside this unit to turn lights off and on. This is not the poor functioning import unit, this is a quality American made switch assembly made to the archive blueprints! Brass contacts are properly formed and housing is cad plated.
Part #
A-13027-QK12
|
Model Year
28-31
This kit gives you everything in the picture. It comes with bulbs, sockets, reflectors, and gaskets for both headlights. Installs easily in any Model A headlight. Puts off light just like your modern car for night driving. You need to have an alternator on your car to run these. 12-volts.
Part #
A-13021-A
Model Year
28-29
Part #
A-13021-B
Model Year
30-31
This is the spring steel clip that is snapped into the top of the headlight bucket that holds the rim on the top. U.S.A.
Part #
A-13114-A
Model Year
28-29
Part #
A-13114-B
Model Year
30-31
Thin rubber pads that fit between the headlight bar and the fender. Thin type without border as original. U.S.A.
Part #
A-13075-SB
|
Model Year
28-29
Special socket used to plug into the bulb when using sealed beam or quartz bulbs. Can't be used with sealed beam bulbs in 1930-31 headlamps. These are made out of very high heat resistant plastic so they will not melt and short when used with quartz bulbs in a Model A headlight bucket.
Part #
A-13073-SA
Model Year
28-28
Part #
A-13073-S
Model Year
29-31
This socket has a flared shoulder at one end to hold it in place. The flared end is captivated between the inside of the headlamp bucket and the base plate that is held in place with 6 rivets. Socket protrudes inward and is what holds the headlamp socket in place that pokes out the bottom of the headlamp. You'll need a set of our A-13011-MB (screws that look like rivets) to re-install the headlamp base plate. Sold individually. U.S.A.
Part #
A-13059
|
Model Year
28-31
Polished stainless bar that clips to A-13047 to hold the rim in place. U.S.A.
Part #
A-13026-TS12
|
Model Year
28-31
This kit is used when installing amber directional bulbs inside your original headlamps. You will have to drill a hole in your reflectors to install this kit. Available in 12-volt only.
Part #
A-13047
|
Model Year
28-31
This is the small clip that sticks out the bottom of the bucket that the "T" bar hooks onto, to hold on the rim. The base plate must be removed to install the clips, so if your headlamp still has the base plate riveted in place, order a set of the A-13011-MB hardware. U.S.A.