Ignition Switch

The replacement cable only to repair your original. This was used on the 1930-31's with a round speedo. Fits original pop out heads that had a removable back plate on the switch. U.S.A.

This is the cap that covers the back of the original pop out switch heads. U.S.A.

The cap used on the original pop out switch to hold the key hole cap in place. U.S.A.

For the original pop out switches, this is the cap where the key goes into the switch assembly. U.S.A.

This authentic American made pre-curved data tag is used on early style popout cables, often called banana popout. U.S.A.

This is a very good quality off-on switch that has been modified to mount and look like the original pop out style switch. When installed, it looks just like the old pop out switch. Genuine Nu-Rex. Your instrument panel must have the cup crimped to the dash panel for mounting this switch. Often people file the original ignition switch hole to a larger size to use an aftermarket ignition switch and remove this cup. U.S.A.

This is the A-11575-EM switch with the pop-out appearing cable that runs down to the distributor. We have installed an end on the cable for easy attaching to switch, genuine Nu-Rex. U.S.A.

Exactly the same switch as our A-11575-EM except this one has an extra terminal on the back for accessories. Genuine Nu-Rex. U.S.A.

This switch assembly will give you the authentic pop-out style switch appearance under the hood, but it uses the replacement style off-on switch. U.S.A.