Ignition Switch

|
Show 9 Of 21
Showing 9 Of 21 results
Part # A-11575-RK1 Model Year 28-29
Part # A-11575-RK2 Model Year 30-30
This replacement cable only fits the original pop out switch heads that had a solid back on them. They were made by Electrolock, Phila., PA. The 1930 cable is slightly longer than the 1928-29 cable. Comes with clamp and grommet. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA
Part # A-11576 | Model Year 28-31
If you're traveling and your ignition fails, this will get you home! Remove your existing ignition cable from the distributor and unhook the red wire from the coil that runs to the ignition switch. Now thread the emergency jumper cable into your distributor and hook the opposite end up to the coil where you removed the red wire. You're on the road again!
DISCONTINUED
Temporarily
OUT OF STOCK
$15.95 EA
Part # A-11575-CLA | Model Year 28-29
This cast design was used from April of 1928 until May of 1929 to hold the pop out cable to the head. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$10.00 EA
Part # A-11576-A Model Year 28-28
Part # A-11576-B Model Year 29-29
Part # A-11576-C Model Year 30-30
Part # A-11576-D Model Year 31-31
Genuine leather key fobs. We have one for the exact year of your car. Natural finish with Ford logo. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA
Part # A-11583 | Model Year 28-31
The double loop design. Stainless. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$2.00 EA
Part # A-11580 | Model Year 19-31

This grommet is used in a couple of different places. One being on the ignition switch wire that runs through the middle of the terminal box on the firewall. This insulates the cable so it doesn't short out on the terminals.

Also replaces the rubber bushing used in the battery support bracket. U.S.A.

DISCONTINUED
Temporarily
OUT OF STOCK
$2.25 EA
Part # A-11556 | Model Year 28-31
Brighten up the dash with a nice new on-off plate. One side on-off or turn over for plain black. ON-OFF side was used from the beginning of production until November of 1928. Thereafter the plain black side was used. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.75 EA
Part # A-11582-C Model Year 30-31
Part # A-11586-A Model Year 28-30

Exact copies of the original Briggs and Stratton ignition key that the 1928-31's used. These blanks only fit the original pop out switches, they do not fit the Re-Pop switches. NOTE: Keys are blanks and must be cut by a locksmith. U.S.A.

DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA
Part # A-11575-CL | Model Year 28-31
The clamp that mounts on the head to hold the cable going to the distributor. Stamped steel style. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$2.45 EA