Part #
A-46168-MB
|
Model Year
28-31
The little flat headed machine screws that hold the slide lock in the door. U.S.A.
Part #
A-9547-MB
|
Model Year
28-31
Special threaded nut that holds the choke arm onto the choke shaft. This nut is thicker than the normal nut. U.S.A.
Part #
A-9582-S
|
Model Year
28-31
A special fine threaded screw that goes on the throttle lever to set the idle. U.S.A.
Part #
A-17255-MB
|
Model Year
28-31
The two screws, nuts, and lock washers needed to mount the speedometer in the instrument panel. U.S.A.
Part #
A-5300-N
|
Model Year
28-31
Set of 8 castle nuts if your old shackles are in good shape. U.S.A.
Part #
A-969-ABSS
|
Model Year
This kit has all of the carriage bolts, nuts, and special square washers to mount the bed strips in the 1928-31 "narrow" style pickup bed. U.S.A.
All hardware in this kit is stainless steel except the special square washers.
Part #
A-11382-SE
Model Year
28-31
Part #
A-11382-S
Model Year
28-31
Special thin headed bolts and special washers to hold the drive spring in place and to hold the drive on the shaft.
Ford used 5/16" on some and 3/8" on others. A-11382-SE and A-11382-S are complete kits. T-5025 and A-11383 are washers only. U.S.A.
Part #
A-11481-BMB
|
Model Year
28-32
Set of 3 tubular rivets and a set of screws, nuts and lock washers. Use either the screws or the rivets to mount the A-11481-B Starter Rod Grommet Cover. Ford Service Bulletins allowed the dealers to reattach the cover with screws instead of rivets for ease of installation. U.S.A.
Part #
A-11481-MB
|
Model Year
28-31
A pair of round headed machine screws with lock washers to bolt the oval style starter rod cover to the firewall. U.S.A.