Floor Boards

|
Show 9 Of 27
27 Results
Part # A-35244 | Model Year 28-31
Round rubber pad and mounting tacks to seal out the dust in the summer, and the cold air in the winter. Just like the original. Nails to the floorboard. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$0.95 EA
Part # A-35150-A Model Year 28-29
Part # A-35150-B Model Year 29-31
Part # WEB-KIT-1040 | Model Year 28-31
The cover that snaps into the opening over the battery in the floorboards. Made of heavy gauge steel with spring steel retaining clips riveted in place as original. Powder coated black. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA
Part # #34-C | Model Year 28-31
Set of black oxide screws and special washers for mounting the center and rear floorboards in the Tudor Sedan. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$5.00 SET
Part # #33-C | Model Year 28-31
Set of black oxide screws and special washers for mounting the floorboards in the car. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$4.00 SET
Part # A-35220 | Model Year 28-28
Early 28's with the emergency brake to the left had this plate installed in the floorboards to allow access to grease the clutch release bearing. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$29.95 EA
Part # A-35130-S Model Year 28-31
Part # A-35130-S2 Model Year 28-31
Part # WEB-KIT-1039 | Model Year 28-31

Black cotton webbing with tacks that gets put around the edge of the floorboards to seal them up. Nails to outside edge, then folds under the board and gets nailed to bottom as well.

If you have a Tudor Sedan, you will also need kit. A-35130-S2 to do the center and rear boards. U.S.A.

DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA
Part # A-35130/31-A Model Year 28-29
Part # A-35130/31-B Model Year 29-31
Part # WEB-KIT-1036 | Model Year 28-31
A 2 piece set for the front of your Model A. All holes are drilled for mounting. The finest you can buy! Made from 7-ply birch hardwood veneer. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA
Part # A-35131 | Model Year 28-31
These metal straps were riveted to the bottom side of the floorboard to support the middle of the front angled floorboard. Comes with mounting rivets as original. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$13.95 PR
Part # A-35131-AR | Model Year 28-28
Used from the beginning of production until around March of 1928. These attached to the under- side of the floorboards for reinforcement. Held on with flat headed wood screws which are included. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$51.50 SET