This is an electronic American made gauge kit. The gauge is a dual faced gauge that will register your oil pressure as well as the water temperature.
Oil pressure measures 0-15 psi, the water temperature measures 100-260 degrees. The kit includes an electronic oil pressure sender and an electronic water temperature sender.
The gauge will fit any standard 2-1/16" gauge holder bracket (not included). The gauge will work on 6 or 12 volt systems, negative or positive ground!
Both senders mount using 1/8" NPT. If you want the gauge to be illuminated, you must purchase the illumination kit separately. 1928-31.
This is an electronic American made gauge kit. The gauge is a dual faced gauge that will register your oil pressure as well as the water temperature.
Oil pressure measures 0-15 psi, the water temperature measures 100-260 degrees. The kit includes an electronic oil pressure sender and an electronic water temperature sender.
The gauge will fit any standard 2-1/16" gauge holder bracket (not included). The gauge will work on 6 or 12 volt systems, negative or positive ground!
Both senders mount using 1/8" NPT. If you want the gauge to be illuminated, you must purchase the illumination kit separately. 1928-31.
This slotted pipe plug goes on the side of the block near the bottom where the oil pump slips up in. You open this to see if your pump is pumping. Quite often you will find a bolt where this plug is supposed to be. U.S.A.
Use this 1/8" pipe thread plug to plug off a vaccum wiper hole in the intake manifold if it is no longer needed.
Magnetic oil drain plug. 3/4-24 thread. U.S.A.
