Flywheel

Complete set of bolts and lock washers to bolt the clutch housing to the flywheel housing.

Special bolts with hole in the head for safety wire lock. Ford number 350645. Torque to 55 lbs.  Our bolts are grade 8.  U.S.A.

Presses into the flange on the back of the crankshaft for aligning the flywheel. U.S.A.

Set of 3 fine threaded bolts and lock washers that hold the 1/2 moon plate A-6398 to the bell housing. U.S.A.

Bracket in this kit bolts to the flywheel. The flywheel is then turned so you can be sure the flywheel housing is correctly shimmed against the block. The small bracket is used to determine if the flywheel is seated properly on the crankshaft. Both of these areas can cause vibration if not properly done. U.S.A.

Good crack free flywheel housings are getting harder and harder to find. This is a new housing cast out of 356T5 aluminum. Weighs 4 lbs. less than original. U.S.A.

Presses into the back of the block to align the flywheel housing when it bolts to the block. U.S.A.

Goes between the flywheel housing and the back of the block. Seals the back of the motor where the cam is. U.S.A.