Part #
B-9525
|
Model Year
32-34
Adjusting needle for the 1932-34 "B" Zenith carburetor used on the 4-cylinder motors. U.S.A.
Part #
B-9528
|
Model Year
32-34
Press in style adjusting needle housing used on the 1932-34 Zenith carburetors. U.S.A.
Part #
B-9595
|
Model Year
32-32
Carburetor rebuilding kit for the 1932-34 Zenith carburetor. The float valve (B-9564) is not included with the carburetor kit and must be purchased seperately if it needs replaced. What you see in the picture is what you get in the kit. U.S.A.
Part #
B-9447-C
|
Model Year
32-34
Copper clad gasket used between the carburetor and intake manifold. Has a slightly larger center hole for the larger B inside diameter. U.S.A.
Part #
B-9582
|
Model Year
32-34
Throttle shaft only that was used on the 1932-34 Zenith carburetors. Arm for end is not included. U.S.A.
Part #
B-9550
|
Model Year
Known as the B-2 style carburetor float, used on 1932-34 Zenith carburetors. The earlier style was more barrel shaped.
Part #
B-9547
|
Model Year
32-34
Brass choke shaft for the 1932-34 "B" Zenith carburetors.
Part #
B-9564
|
Model Year
32-34
Float valve (needle/seat) for the 1932-34 B Zenith carburetors. Viton tipped style needle which seals much better than the stock needle valve. U.S.A.
Part #
B-9576
|
Model Year
32-34
A complete set of 10 plugs for the 1932-34 Zenith carburetor that was used on the 4-cylinder motors. This carburetor is often used on Model A's for improved performance and air flow. Kit has plugs for both the B-1 and the B-2 carburetor. Instruction sheet included. U.S.A.