Gaskets & Parts

Shaft only, arm is not included. A-9582-A is used with cast brass throttle levers. A-9582-B is used with stamped steel levers. U.S.A.

If your carb housing is worn badly where the throttle shaft goes through, this kit will take care of it. Brings the holes back to standard size! Knurled! U.S.A.

Used on the throttle shaft of the Tillotson carburetors. U.S.A.

If this shaft is worn, it can cause your motor to run poorly at idle. It is important that the shaft fits well in the carb. Standard version that is .281/.282" dia. Shaft is brass, lever is cad plated. U.S.A.

Throttle shaft with lever for the Tillotson carb. Won't work on cast iron Tillotsons. U.S.A.

Set of 4 screws and lock washers for securing the choke and throttle plates to the shafts on Tillotson carburetors. U.S.A.

A brass float for the tillotson carb. Will not fit the odd Tillotson carburetor that looked like a Zenith carburetor. U.S.A.

All the needles, jets, and float valve for the Tillotson carb. This kit only works on pot metal Tillotson carbs with the bowl that is held on with 3 screws. They are also sometimes identified as model "X" or model "XF". There is a Carter carburetor that is often confused as being a Tillotson but nothing will interchange for those. The Carter can easilly be idenfified by having 4 screws holding the bowl on and several serial numbers cast into the bowl. U.S.A.

The gaskets only for the pot metal Tillotson carb. Will not work on the cast iron or pot metal version that looked like the Zenith model A carburetor. The Tillotson that this kit fits is the pot metal version that had 3 screws holding the bowl on. U.S.A.