Gaskets & Parts

|
Show 36 Of 51
Showing 36 Of 51 results
Part # A-9547-MB | Model Year 28-31
Special threaded nut that holds the choke arm onto the choke shaft. This nut is thicker than the normal nut. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$0.50 EA
Part # A-9582-S | Model Year 28-31
A special fine threaded screw that goes on the throttle lever to set the idle. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$0.45 EA
Part # A-9559-B Model Year 28-31
Part # A-9559-C Model Year 30-31
Fuel strainers for the Zenith carburetors. Late '31 side-bowl carburetors did not use these. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA
Part # A-9559 | Model Year 28-31

Screen only if you want to use your old hex for the carburetor strainer. Zenith only. 1928-31. U.S.A.

DISCONTINUED
Temporarily
OUT OF STOCK
$4.95 EA
Part # A-9631 | Model Year 28-31
Made of brass for long life. Will not work on cast iron carbs. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$2.50 EA
Part # A-9585 | Model Year 28-31
A good heavy throttle plate for the Zenith carbs. Made of brass as original with the correct angles on the edges. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$7.75 EA
Part # A-9582-A Model Year 28-29
Part # A-9582-B Model Year 28-31
Shaft only, arm is not included. A-9582-A is used with cast brass throttle levers. A-9582-B is used with stamped steel levers. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA
Part # A-9581-BU | Model Year 28-31
If your carb housing is worn badly where the throttle shaft goes through, this kit will take care of it. Brings the holes back to standard size! Knurled! U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.95 PR
Part # A-9581 Model Year 28-31
If this shaft is worn, it can cause your motor to run poorly at idle. It is important that the shaft fits well in the carb. If your casting is worn, you can drill out the holes and use an oversize one. Zenith carbs. U.S.A.
DISCONTINUED
Temporarily
OUT OF STOCK
$1.00 EA