Part #
A-18800-DVD
Model Year
28-31
An excellent movie that deals strictly with the Zenith carb. Covers 17 different Model A carbs. Shows how to rebuild the rusty swap meet carb! How to check and clean the passageways.
How to size jets and flow-test them, how to set float level. These are just a couple of the areas covered in the movie. It will take you from A to Z on the Model A carb. 50 minutes.
Part #
A-9528
|
Model Year
28-31
For Zenith and Tillotson carbs. Has 1/8" npt threads where it threads into the carburetor. A-9525 adjusting needle threads inside this part. U.S.A.
Part #
A-9525
|
Model Year
28-31
The brass adjustment needle that is controlled by your choke rod. This is an important item to your car's performance. Make sure that your point is in good shape. U.S.A.
Part #
M-205
|
Model Year
09-31
16oz Aerosol semi-gloss black enamel. Gas resistant, works great on carburetors or anywhere else throughout where a semi gloss black paint is required. 300 degree temp rating. U.S.A.
Part #
A-9538
|
Model Year
28-31
For the Zenith carb. Threads into the carburetor bowl through the venturi hole. U.S.A.
Part #
A-9532
|
Model Year
28-31
The adjustment needle went into this brass seat in the 28-9 Zenith carbs. The later carbs were machined in the carb casting and didn't use this one. Don't get this seat confused with the A-9575 compensator jet! This jet has a taper for the A-9525 adjusting needle to engage. U.S.A.
Part #
A-9549-MB
|
Model Year
28-31
Set of four small fine threaded screws that attach the choke and throttle butterflies to the shafts. U.S.A.
Part #
A-9590
|
Model Year
28-34
Brass drain plug will work on Zenith or Tillotson carburetors. Brass was correct for 1928-29's. U.S.A.
Part #
A-9590-C
|
Model Year
30-31
Cad plated drain plug will work on Zenith or Tillotson carburetors. Cad was correct for 1930-31's. U.S.A.