Bumpers & Parts

When ordering this part, you will get the two bumpers, just like you see in the drawing. All other hardware and clamps must be purchased separately. 64-1/2" long. Available in chrome or stainless.  U.S.A.

Sold as a pair, right and left. You get the bars with the plate already riveted to the bars for mounting. All other hardware must be purchased separately. U.S.A.

When you buy this part number you are getting the two bars. All other front bumper hardware must be purchased separately. 62-7/8" was used from the beginning of production until August of 1930, 60" was used from then on, but any of the three will work. U.S.A.

Sold as a set like you see in the drawing. Set will give you 4 bars. All other hardware must be purchased separately. U.S.A.

This is the small backing plate for the center bumper clamp. This wider style was used on the 28-9's that used the round style center clamp. U.S.A.

This heavy steel backing plate is the early design. It was used from the beginning of production until around March of 1930. Powder coated black! U.S.A.

The later style stamped steel design with the diamond shape reinforcement stamped in it. Used from March of 1930 until the end of production, but will work on any year. Powder coated black! U.S.A.

The bolts, nuts, and lock washers needed to install the rear bumper brackets and the cross brace. The bolts included for the cross brace are standard bolts, not the autnentic style black oxide with the special heads like we sell separately. U.S.A.

3/8" x 1-1/8" round headed steel rivet used to rivet the body stands (A-17830-A, -B, -C) to the bumper bracket. U.S.A.