Part #
A-2000
|
Model Year
28-36
Used on 1939-48 hydraulic brakes on 1928-36 spindles. Large ring centers backing plate on spindle, small ring slides over spindle behind the inner bearing. U.S.A.
Part #
A-2027
Model Year
28-32
Part #
A-2027-Q8
Model Year
A set of 8 cad plated pins for the brake adjusting shaft. This is the pin that holds the A-2042 adjustng shaft onto the brake shoe. U.S.A.
Part #
A-2504-MB
|
Model Year
28-31
A 12 piece set for mounting both types of anti-rattle springs. 4 bolts, 4 nuts, 4 washers. U.S.A.
Part #
A-2248
Model Year
28-31
Part #
A-2249
Model Year
28-31
Part #
A-2250
Model Year
28-31
Special cadium plated bolts and nuts that hold the rear backing plates and the radius rod to the axle housing. U.S.A.
Part #
A-2248/50
|
Model Year
28-34
Special cadium plated bolts and nuts that hold the rear backing plates and the radius rod to the axle housing. The A-2248/50 set contains 2 long bolts, 2 short bolts, 4 nuts, and 4 cotter pins. One set does 1 wheel.
Part #
A-2042
|
Model Year
28-31
These are the clevises that mount on the end of the brake shoe and rest against the brake adjusting wedge. Need 8 per car.
Part #
A-2041
|
Model Year
28-34
This is the wedge with the square on the end that sticks through the backing plate so that you can adjust the brakes. U.S. made, plated, and heat treated! Need 4. U.S.A.
Part #
A-2041-T
|
Model Year
28-31
This tool is made special to slip over the square end of the adjusting wedge A-2041. And used to adjust the brake. Cad plated finish. U.S.A.
Part #
A-2478/79
|
Model Year
28-31
The brackets that mount the brake cross shaft to the frame. 1 set does both sides. Powder coated black! U.S.A.