Part #
A-4242
|
Model Year
28-48
Castellated nuts used to attach the rear hubs. U.S.A.
Torque to 100 foot pounds.
Part #
A-4035-S
|
Model Year
28-31
This gasket set takes care of the rear axle and the universal joint. 9 piece set. U.S.A.
Part #
B-4035-S
|
Model Year
32-48
Rear end gasket set for the 1932-48. Kit includes: fiber hub washers, speedo drive gear housing gasket, torque tube to banjo gasket, u-joint housing cap gaskets -w- cork strip, and 4 pairs of axle housing gaskets, .003, .005, .007, and .009. U.S.A.
Part #
A-4235-G
Model Year
28-34
Part #
A-4235-G6
Model Year
28-31
Available in either .006 or .010 thick for shimming the ring & pinion. Large gaskets that go between the axle housings and the axle center section. U.S.A.
Part #
A-4024
|
Model Year
30-31
Ford started making the rear spring perch ball as a separate piece in February of 1930. U.S.A.
Part #
A-4010-B
|
Model Year
28-31
These axle housings have the following things done to them: new A-4222 race installed, new A-4245 seal installed, shock ball replaced if necessary, shackle bushing hole repaired with new bushing, new A-1225-SL bearing sleeve installed in end. They are sold on exchange only. We must have your old axle housing in our hands before we will ship a rebuilt one out. Please do not send us an axle housing that has been laying in the mud or outside for the last 50 years because it will not be considered rebuildable. U.S.A.
Part #
A-4020
Model Year
28-34
Part #
A-4020-Q4
Model Year
For the rear leaf spring and the rear perches. Duplicate of the originals. Bushings need to be reamed/drilled after they are pressed into place. U.S.A.
Part #
A-4221-SH
|
Model Year
28-31
Use this .005" thick shim between the A-4221 Bearing and the differential gear case to compensate for wear. Assemble your rear end with out any gaskets between the axle housing and center section, if axle locks, you are good and don't need these shims. If axle turns freely, add shims until axle locks. Sold individually. U.S.A.