Part #
A-4637
|
Model Year
28-31
Goes behind the pinion bearing nut. U.S.A.
Part #
A-4243-A
|
Model Year
28-31
Locks the pinion gear in place on the end of the drive shaft. U.S.A.
Part #
A-4636
|
Model Year
28-47
The ears of this washer get bent around the pinion bearing nut to secure them in place. Should always be replaced. USA
Part #
A-4634-T
|
Model Year
28-31
Laser cut from 1/4" steel. Not a Craftsman, but it does the job! U.S.A.
Part #
A-4210-T
|
Model Year
28-31
This tool is used for removing the drive shaft, pinion cup, and pinion gear assembly from the rear end. U.S.A.
Part #
A-4210-X
|
Model Year
28-31
Used for removing and installing the pinion bearing assembly in the center axle section.
Part #
A-4750-MB
|
Model Year
28-32
This is the larger sized bolt, nut and cotter pin that attach the rear radius rods to the torque tube just behind the U-joint. U.S.A.
Part #
A-4244
|
Model Year
28-48
A heavy fiber washer that goes in the recess of the hub under the axle washers (A-4244-SW). U.S.A.
Part #
A-4243
|
Model Year
12-48
Check your old keys to be sure that they aren't worn. Because worn keys can damage the keyway and axles cost more than keys. U.S.A.