Part #
A-3122/24
|
Model Year
28-31
Special bolt, nut, and lock washer that locks the spindle bolt in place in the axle. Nut goes on back side of axle and provides the stopping point for the spindle when the wheels are turned. U.S.A.
Part #
A-3107
|
Model Year
28-31
The thin washer used to take up any up and down play in the king pins. U.S.A.
Part #
A-3123
|
Model Year
28-31
Two of these bearings are needed for the steering worm. (7-tooth sector). Also used as a thrust bearing for the king pin. U.S.A.
Part #
A-3111-KPO
|
Model Year
28-31
A worn spindle bolt is one of the greatest causes of a front end shimmy, and hard steering. Our spindle set replaces all wearing parts for both right and left sides.
Part #
A-3125
|
Model Year
28-31
This one goes at the lower end inside the cup washer. U.S.A.
Part #
A-3036-W
|
Model Year
19-31
Front spring perch nuts shims are used to compensate for wear on the radius rod where the nut seats. The radius rods are often worn from years of neglect. When this happens, the perch nut bottoms out on the shoulder of the perch instead of the radius rod. Sold in pairs. U.S.A.
Part #
A-3131
|
Model Year
28-31
This is the double ball style arm that is used on the left. They are original steering arms that have new balls installed. They are sold on exchange only, so we must have your old arm before we can ship out a rebuilt one. Must be free of grease and oil when you send your old one in. If the shank between the ball and the arm is badly worn, it can not be rebuilt. Left hand drive only. U.S.A.
Part #
A-3130
|
Model Year
28-31
This is the single ball style steering arm that is used on the right side. They are original steering arms that have new balls installed. They are sold on exchange only, so we must have your old arm before we can ship out a rebuilt arm. must be free of grease and oil when you send your old one in. If the shank between the ball and the steering arm is badly worn, they can not be rebuilt. Left hand drive only. U.S.A.
Part #
A-3034-X
|
Model Year
28-31
Used to remove and install the A-3034 shackle bushings.