New Category

|
Show 90 Of 1000
Showing 90 Of 1000 results
Part # T-5119-AX | Model Year 19-27

A 50 amp alternator that resembles the original model T generator. Will only work on 12-volt negative ground systems.  You just have to attach a wire to the terminal that is only hot when the ignition switch is turned on. 

It has mounting screws and hardware included to mount a cut-out for appearance only. Your hot wire will have to go directly to the terminal on the alternator.  If you want the wire to hook up to the cut out as original, you'll have to open up the cut out, cut it out and attach a wire to link the terminals together. 1 year warranty 

Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$549.95 EA
Part # T-5099-12 | Model Year 19-27

A 12-volt gear reduced starter for your model T. Eliminates the excessive force applied to the factory ring gear when using the factory 6-volt starter on 12-volts.

Starter has a built in solenoid. 1 year warranty

Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$475.00 EA
Part # T-4588-D | Model Year 23-25
This rod runs from your dash panel through the firewall, and hooks to the bell crank on the engine side of the firewall. From the bell crank to the carb is just a piece of wire. Rod is 13-1/16" long, used on 1923-25.  U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$9.50 EA
Part # T-3926-B | Model Year 13-16

Polished brass low fin style that was originally used from 1913-16.

Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$21.00 EA
Part # T-4588-B | Model Year 19-22
This rod runs from your dash panel through the firewall, and hooks to the bell crank on the engine side of the firewall. From the bell crank to the carb is just a piece of wire. Rod is 13-9/16" long and is used on 1919-22 Coupe, Roadster, and Touring cars. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$10.75 EA
Part # T-6206-B | Model Year 14-23
Choke lever/shaft for the Holley NH carb. Comes with spring. This early style is about 1-7/8" center to center of holes. 1914-23 U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$33.50 EA
Part # T-6206-A | Model Year 14-23
Throttle lever/shaft for Holley NH carbs only. the dimension listed with the part numbers is from the center of the shaft out to the center of the hole where the rod hooks on. Early style that was used on 1914-23 T's. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$33.50 EA
Part # T-5201-ADP | Model Year 09-27
Adapts the pipe threaded T head to accept modern 14MM spark plugs. Brass. Sold in sets of 4. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$19.95 SET
Part # T-4588-F | Model Year 23-25
This rod runs from your dash panel through the firewall, and hooks to the bell crank on the engine side of the firewall. From the bell crank to the carb is just a piece of wire. Rod is 16-1/16" long, used on 1923-25 Tudor Sedan and Fordor Sedans. U.S.A.
Drop shipped from manufacturer, allow Weeks
Made To Order, Allow Weeks
DISCONTINUED
Temporarily
OUT OF STOCK
$9.50 EA