New Category

We stock the authentic battery cable with a woven loom and an off set design clamp just like Henry used. This cable runs from the battery to the starter switch. 2/0 cable. 35" long. U.S.A.

The complete battery cable support bracket with rubber bushing. This is the authentic version for the show cars. U.S.A.

The complete battery cable support bracket with rubber bushing. U.S.A.

Original style battery carrier. Heavy metal frame riveted together. U.S.A.

Holds the battery in place on the drivers side behind the running board on TT trucks. U.S.A.

Board is 7/8" thick and notched on ends to rest in the bottom of your battery carrier. When using a modern battery in your "T", this will raise the height of your battery so original style clamps can be used to hold battery.

Diaphram only for the battery style horn. When the old ones get rusty or have rust holes in them, the tone isn't correct.

Presses over the shaft of the generator behind the gear to prevent motor oil from getting into the generator.  Presses up against the bearing. USA 

Same tool as used in the 20's for scraping babbit bearings to fit crankshafts. Hollow ground triangular blade stays sharp.