Part #
T-3369
|
Model Year
09-27
Standard version, 1.562" bore. This bearing takes the full weight of the transmission so it is important that it fits snugly. Sold on exchange basis only. WE MUST HAVE YOUR OLD ONE BEFORE WE CAN SEND A NEW ONE! U.S.A.
Part #
T-2728-C
|
Model Year
09-27
This is the seat for the accessory style spring loaded radius and tie rod cap assemblies. U.S.A.
Part #
T-3363-GS
|
Model Year
09-27
All the gaskets needed when removing the transmission cover to change the bands. U.S.A.
Part #
T-3423-X
|
Model Year
09-27
A handy plier type tool used to properly form the split rivets that hold the transmission linings to the bands. U.S.A.
Part #
T-3419-T
|
Model Year
09-27
This special tool holds the band adjusting nut and washer so they don't get dropped in the transmission when you install them. U.S.A.
Part #
T-3423-BT
|
Model Year
09-27
This handy tool rolls the split rivets around and imbeds the rivet into the lining. Can also be used for installing hood lacing split rivets.
Part #
T-3415
|
Model Year
09-27
Special washers used to lock the band adjusting nuts in place inside the transmission. 2 required. U.S.A.
Part #
T-9004
|
Model Year
26-27
Steel plate that covered the battery access hole in 1926-27 steel pickup beds. U.S.A.
Part #
T-5046
|
Model Year
19-27
We stock the authentic battery cable with a woven loom and an off set design clamp just like Henry used. This cable runs from the battery to the starter switch. 2/0 cable. 35" long. U.S.A.