Model A Ford Radius
Note: On radius ball assmblies, From the factory the Model A had the A-3440-S style radius kit. The A-3440 RE kit is a replacement style kit that was offered by aftermarket companies at a later date. The A-3440-RE kit uses a rubber ball to take up slop from a worn radius ball. A-3440-S is a more durable kit.
Model A Tie Rod
$14.95 / ea.
This is the rod only to replace a bent or rusty one.
Model A Tie Rod Ends
Finally, good quality tie rod ends are available.
Model A Tie Rod Bolts
$5.00 / set
A six piece set of hardware to hold the tie rod ends to the rod.
$105.00 / ea.
One end clamps on the tie rod, and the end mounts to the front axle.
Model A Drag Link
$64.95 / ea.
This is the link that runs from the pitman arm at the steering box to the front steering arm.
Model A Tie Rod/Drag Link Rebuild
$9.75 / set
All the parts needed to replace the small parts in the ends of the tie rod and the drag link.
Model A Tie Rod/Drag Link End Plug Tool
$5.00 / ea.
This tool removes the threaded end plugs in the tie rod and drag link ends.
Model A E-Z Steer Kit
$36.95 / set
For both the tie rod and the drag link.
Model A Teflon Seats
$19.95 / set
If you have already purchased the E-Z Steer Kit (A-3305-SE) and need to replace only the teflon, this is the kit.
Model A Weld In Ball Stud
$4.50 / ea.
If your steering balls are worn, it is best to replace them.
Model A Tie Rod/Drag Link Seal
$4.00 / set of 4
The rubber seal that keeps grease in and the dirt out of the ie rod & drag link.
Model A Metal Cap
$4.50 / set of 4
The cap that holds the rubber seal in place on the tie rod and drag link ends.