keyboard_arrow_left
keyboard_arrow_right
clear
keyboard_arrow_left
zoom_in
keyboard_arrow_right
zoom_in
SINGLE DOWNDRAFT INTAKE MANIFOLD
Part #
A-9425-SGL
|
Model Year
28-34
Convert your Model A to downdraft instead of updraft. This arrangement will allow more fuel/air to enter the engine for increased performance. Carb flange is machined to accept early V8 carbs. Aluminum. U.S.A.
Part #
A-9426
|
Model Year
28-34
Burns style throttle arm for use with downdraft intake manifolds. 8-1/2" overall in length. Pivot hole is 5/16". Cast aluminum and shot peened. USA
Part #
A-9430-N
|
Model Year
28-34
A set of 4 brass nuts used to mount the manifold. Brass won't corrode! U.S.A.
Part #
A-9431
|
Model Year
28-34
Set of 4 studs that screw into the block to mount the manifold. Our studs are American Made and are grade 8 material.
Part #
A-9433-C2
|
Model Year
31-31
For the show car, we can offer the correct style of manifold gaskets. Copper with composition in the middle. This particular version was used from May of 1931 until the end of production but will work on any year. Sold in pairs. U.S.A.
Part #
A-9433-F
|
Model Year
28-34
The one piece manifold gasket. Composition material with steel covering. 17-3/4" long. U.S.A.
Part #
A-9443
|
Model Year
28-31
Extra heavy cup shaped washers that hold the intake and exhaust manifolds in place. The crown or high point of the washer goes away from the motor. U.S.A.