keyboard_arrow_left
keyboard_arrow_right
clear
keyboard_arrow_left
zoom_in
keyboard_arrow_right
zoom_in
HOLE PLUG
Part #
A-6621
|
Model Year
28-31
This slotted pipe plug goes on the side of the block near the bottom where the oil pump slips up in. You open this to see if your pump is pumping. Quite often you will find a bolt where this plug is supposed to be. U.S.A.
Use this 1/8" pipe thread plug to plug off a vaccum wiper hole in the intake manifold if it is no longer needed.
Part #
A-6621-R
|
Model Year
28-34
Use this handy fitting to hold the pump in place when you remove or install the oil pan. The fitting threads in where the slotted pipe thread plug goes on the side of the block between the oil pan and the valve cover at the center. Once it is installed, you thread the bolt in the center of the fitting in against the oil pump so it won't fall out. You thread this bolt in just snug enough to hold the pump, do not over tighten or you will bust the oil pump casing. U.S.A.