keyboard_arrow_left
keyboard_arrow_right
clear
keyboard_arrow_left
zoom_in
keyboard_arrow_right
zoom_in
WINDSHIELD DELUXE PLAIN
Part #
A-37110-BPD
|
Model Year
30-31
1930-31 Deluxe Open Car Windshield Frame. Plain Steel. Made from the original style round tubing. The holes are drilled and tapped for the Windshield Studs. The holes are drilled to accept the Finger Pulls in the bottom tube.There are no holes drilled in the top tube for the top snaps.
13 1/2" high at the end. Made in the USA.
Fits 1930-31 Deluxe Roadster & Deluxe Phaeton
Part #
A-3402-X
|
Model Year
28-31
Black rubber used to seal the glass to the windshield frame. Give a light coat of oil when installing and rubber will swell to make a nice tight seal. U.S.A.
Part #
A-351000
|
Model Year
26-36
A nice chrome plated wing nut (3/8-24 thread).
- On a Model A: Used on the open car All years 28-31 used them at the top where the windshield pivots. The 1930-31 also uses them to attach the upper stanchion to the lower stanchion. Therefore a 1928-29 requires two and a 1930-31 requires four.
- On a Model T: Used to lock the windshield in place on the stanchion. 1923-25 requires two, 1926-27 requires 4.
Part #
A-37103
|
Model Year
30-31
This set has the male studs that screw into the windshield post and the snaps that go on the top of the windshield frame that the side curtains and the top to attach to.
Part #
A-37118
|
Model Year
28-36
Mount on the lower horizonal part of the windshield frame for pulling it shut. On all open cars.
Part #
A-37154-RC
|
Model Year
30-31
Installs between windshield frame and windshield stanchions at the pivot point. Open cars only. These are a quality American made cone with the proper taper. U.S.A.
CHROME PLATED
Part #
A-37154-RP
|
Model Year
28-31
Installs between windshield frame and windshield stanchions at the pivot point. Open cars only. These are a quality American made cone with the proper taper. U.S.A.
PLAIN STEEL
Part #
A-37158
|
Model Year
21-31
Open cars used these studs where the windshield pivoted. Special thin cone shaped nut for holding the frame cones are included. Set consists of 2 studs and 2 nuts. U.S.A.
Part #
A-37199-B
|
Model Year
30-31
Rubber seals that seal the sides and bottom of the 1930-31 Roadster, Roadster Pickup, and Phaeton windshield frame. Uses a 1" x 46" long "T" shaped piece in the bottom of the windshield frame and a 1/2" x 32" "T" shaped piece that inserts in the vertical sides of the frame to seal the sides. USA